Introduction
If you own a 2017 Ford Explorer, you may have wondered about the battery type used in its key fob. The key fob is an essential component of your vehicle, allowing you to lock, unlock, and start your car remotely. In this article, we will discuss the battery type required for the key fob and provide you with some useful tips.
Understanding the Key Fob
The key fob for the 2017 Ford Explorer is a small, handheld device that communicates with your vehicle’s security system. It uses radio frequency signals to perform various functions, such as locking and unlocking the doors, opening the trunk, and activating the panic alarm.
Battery Type
The key fob for the 2017 Ford Explorer requires a CR2032 lithium coin cell battery. This type of battery is commonly used in electronic devices due to its long-lasting power and reliability. It is readily available in most stores that sell batteries.
Replacing the Battery
To replace the battery in your 2017 Ford Explorer key fob, follow these simple steps:
- Locate the battery compartment on the back of the key fob. It is usually a small, rectangular slot.
- Using a small flathead screwdriver or a coin, gently pry open the battery compartment.
- Remove the old battery and dispose of it properly.
- Insert the new CR2032 battery into the compartment, ensuring that the positive (+) side is facing up.
- Close the battery compartment by pressing it firmly until it snaps into place.
Tips for Battery Life
To optimize the battery life of your key fob, consider the following tips:
1. Keep Your Key Fob Away from Electronics
Electromagnetic fields emitted by electronic devices can interfere with the signals from your key fob, draining its battery faster. Avoid storing your key fob near devices such as mobile phones, laptops, or tablets.
2. Don’t Press Buttons Unnecessarily
Pressing buttons on your key fob unnecessarily can drain the battery. Be mindful of accidentally pressing any buttons while the key fob is in your pocket or purse.
3. Replace the Battery Promptly
If you notice a decrease in the key fob’s performance, such as reduced range or intermittent signal transmission, it may be time to replace the battery. Promptly replacing the battery can prevent any inconvenience caused by a dead key fob.
Conclusion
The 2017 Ford Explorer key fob requires a CR2032 lithium coin cell battery. By following the simple steps provided, you can easily replace the battery when needed. Remember to optimize the battery life by keeping the key fob away from electronics, avoiding unnecessary button presses, and replacing the battery promptly when necessary. With a well-functioning key fob, you can enjoy the convenience and security it provides for your 2017 Ford Explorer.