Introduction
As a proud owner of a 2020 Ford Expedition, you may be wondering how to replace the key fob battery. A key fob is a convenient accessory that allows you to lock, unlock, and start your vehicle with ease. However, like any battery-powered device, the key fob battery will eventually need to be replaced. In this article, we will guide you through the process of replacing the key fob battery in your 2020 Ford Expedition.
Step 1: Gather the Required Tools
Before you begin the battery replacement process, ensure that you have the necessary tools at hand. You will need a small flathead screwdriver or a plastic pry tool, a fresh CR2032 battery, and a clean cloth. These tools will help you safely remove the old battery and install the new one.
Step 2: Locate the Battery Compartment
The next step is to locate the battery compartment on your Ford Expedition’s key fob. Flip the key fob over to the backside and look for a small indentation or a slot. This is where you will insert the screwdriver or pry tool to open the key fob.
Step 3: Open the Key Fob
Insert the screwdriver or pry tool into the slot and gently pry open the key fob. Be careful not to apply too much pressure, as you don’t want to damage the key fob or the internal components. Once the key fob is open, set aside the top cover and locate the old battery.
Step 4: Remove the Old Battery
Using the screwdriver or your fingers, carefully remove the old battery from its compartment. Take note of the battery’s orientation, as you will need to install the new battery in the same position. Dispose of the old battery properly, as it may contain hazardous materials.
Step 5: Clean the Battery Compartment
Before installing the new battery, it is important to clean the battery compartment. Use a clean cloth to wipe away any dirt or debris that may have accumulated. A clean battery compartment ensures proper contact between the new battery and the key fob’s internal components.
Step 6: Install the New Battery
Take the fresh CR2032 battery and align it in the same orientation as the old battery. Gently press the new battery into the compartment until it fits securely. Ensure that the battery is properly seated and making contact with the key fob’s terminals.
Step 7: Close the Key Fob
With the new battery installed, it’s time to close the key fob. Align the top cover with the bottom half of the key fob and firmly press them together. You may hear a click or feel the key fob snap shut. This indicates that the key fob is securely closed.
Step 8: Test the Key Fob
After replacing the battery, it’s important to test the key fob to ensure it is functioning properly. Stand near your vehicle and press the lock and unlock buttons on the key fob. If the vehicle responds accordingly, congratulations, you have successfully replaced the key fob battery.
Step 9: Properly Dispose of the Old Battery
Remember to dispose of the old battery responsibly. Many retail stores and recycling centers accept used batteries for safe disposal. Do not throw the battery in the trash, as it can be harmful to the environment.
Conclusion
Replacing the key fob battery in your 2020 Ford Expedition is a simple process that can be done at home with minimal tools. By following the steps outlined in this article, you can ensure that your key fob continues to operate smoothly and efficiently. Remember to always use a fresh battery and dispose of the old one responsibly. Enjoy the convenience of your key fob and have peace of mind knowing that you can easily replace its battery when needed.