Changing Battery In Equinox Key Fob

How to replace key fob battery chevy YouTube
How to replace key fob battery chevy YouTube from www.youtube.com

Changing Battery in Equinox Key Fob

Introduction

The Equinox key fob is an essential component for operating your Chevrolet Equinox. Over time, the battery in the key fob may lose its charge and need to be replaced. In this article, we will guide you through the process of changing the battery in your Equinox key fob, ensuring that you can continue to use it efficiently.

Step 1: Gather the Necessary Tools

Before you begin, make sure you have the required tools. You will need a small flathead screwdriver and a replacement battery. The specific battery type may vary depending on the year of your Equinox, so consult your vehicle’s manual or contact a Chevrolet dealership to determine the correct battery size.

Step 2: Locate the Battery Compartment

Flip the key fob over and locate the small indentation on the rear cover. Insert the flathead screwdriver into the indentation and gently pry open the cover. Be careful not to apply too much pressure to avoid damaging the key fob.

Step 3: Remove the Old Battery

Once the cover is open, you will see the battery compartment. Use the screwdriver to carefully lift the old battery out of its slot. Take note of the battery’s orientation so that you can insert the new battery correctly.

Step 4: Insert the New Battery

Take the new battery and align it properly with the slot in the key fob. Ensure that the positive (+) side of the battery is facing up. Gently press down on the battery until it is securely in place.

Step 5: Close the Battery Compartment

Once the new battery is inserted, line up the rear cover with the key fob and press it firmly until it snaps back into place. Make sure the cover is securely closed to prevent any water or dust from entering the key fob.

Step 6: Test the Key Fob

Now that you have replaced the battery, it’s time to test the key fob. Stand close to your Equinox and press any button on the key fob. If the key fob successfully locks or unlocks the doors, then you have successfully changed the battery.

Conclusion

Changing the battery in your Equinox key fob is a simple process that can be done at home with minimal tools. By following these steps, you can ensure that your key fob continues to function properly and allows you to access your vehicle conveniently. Remember to dispose of the old battery responsibly and refer to your vehicle’s manual or a dealership for any specific instructions or variations based on the year of your Equinox.